Measuring frame slow to boot up.
Verfasst: Do 28. Feb 2019, 15:07
Hi.
One of our MF5R1 measuring frames seems reluctant to start up, and can take over 60 minutes to join the network, although once it does eventually start up, it works ok.
When we initially power the system up the lane monitor shows the calibration details from the frame, but then this stays on screen, with no target showing. While this is going on, the measuring frame isn’t viewable via the network test in Shootmaster.
When the frame eventually connects to the network, carrying out a network test shows that Device Type “ESTMf5” is missing from the device type list, when comparing the frame to those working normally.
The linked screen grab shows the results of the network test. The frame in question has the IP address 192.168.11.4
[img][https://share.icloud.com/photos/0CgZsGM ... otland/img]
One of our MF5R1 measuring frames seems reluctant to start up, and can take over 60 minutes to join the network, although once it does eventually start up, it works ok.
When we initially power the system up the lane monitor shows the calibration details from the frame, but then this stays on screen, with no target showing. While this is going on, the measuring frame isn’t viewable via the network test in Shootmaster.
When the frame eventually connects to the network, carrying out a network test shows that Device Type “ESTMf5” is missing from the device type list, when comparing the frame to those working normally.
The linked screen grab shows the results of the network test. The frame in question has the IP address 192.168.11.4
[img][https://share.icloud.com/photos/0CgZsGM ... otland/img]